Bracket that mounts a BTT SFS 2.0 to a Voron M4 on an Ender3 v2 for clean routing and better reliability.
This bracket adapts the BTT SFS 2.0 filament sensor to the Voron M4 extruder on an Ender3 v2, giving you a clean, stable mounting point that avoids hacks and zip-tie fixes. Designed for consistent filament detection and smoother cable management, it installs fast and fits tight.
Ideal for anyone upgrading an Ender3 v2 with Voron hardware or looking to reduce wasted prints caused by runout failures.
Printing Technology: FDM
Layer Height: 0.2 mm
Perimeters: 6
Infill: 10%
Infill Pattern: Gyroid
Recommended Material: PLA, PETG, ABS, ASA
Supports: No
Support Type: None
Notes:
- Designed to be printed without supports- Tested in ABS
Materials Needed:
1x BTT SFS 2.0
1x Voron M4 Extruder
1x 40mm PTFE tubing
2x Heatset inserts
5x M3x8 screws
Instructions:
1. Determine if you will need regular or mirrored bracket, and print
2. Insert heatsets in outer holes of lower bracket
3. Mount BTT SFS 2.0 to upper bracket mount
4. Mount bracket to Voron M4 via two outer holes in M4 extruder
5. Run PTFE tubing from BTT SFS2.0 to extruder
6. Plug in cabling
By using the customization software, you agree to our Privacy Policy, Terms of Service, Disclaimer, EULA, and Cookie Policy.
The files provided here are for personal, non-commercial use only. Redistribution, modification, or commercial use is not allowed without prior written consent from Lunar Prototypes.